Non-Clog Sewage Pumps

4" Non-Clog Sewage Pumps Series

Application:

High capacity water removal - parking lots - low flood areas - water transfer;
Retrofit on existing sewage installations;
New installations;

Guide Rail Systems:

  • • 4” pipe flange fittings
    • Model: 100GAK
    • Automatic engagement
    • Easy disengagement
    • Class 30 cast iron fittings
    • S.S guides, upper guide rail bracket, bolts and lock washers
    • Optional: Bronze mounting plat

 

 

FEATURES AND BENEFIT:
1. Triple sealed cable entrance
2. Strong motor, Class H insulation
3. Severe duty dual mechanical seals
4. High efficiency hydraulic desigh
5. Moisture detection

Specifications:

      • DISCHARGE: 4" horizontal flange - Standard ANSI flange
      • TEMPERATURE: 104ºF(40ºC) Continuous
      • IMPELLER: Enclosed 2 Vane impeller with features backside pump out vanes, keeping the lower mechanical                  seal clean and pressure compensated for long life. Material:ductile iron
      • SOLIDS HANDLING: 3"(76.2mm) spherical
      • SEAL: Dual mechanical shaft seals, motor side: Rotating faces-Carbon
                  Stationary faces-Silicon Carbide
                  pump side: Rotating faces-Silicon Carbide
                  Stationary faces-tungsten carbide
                  300 series Stainless Steel Parts
      • CABLE ENTRY: 40ft Cord, Epoxy sealed. Housing with secondary pressure grommet for sealing and                        strain relief. U/L listed cord
      • SPEED: 4 Poles --- 1750RPM (Nominal)
                     6 Poles --- 1150RPM (Nominal)
      • UPPER BEARING: Single row,ball design oil lubrication, radial load
      • LOWER BEARING: Double row,ball design oil lubrication, radial & thrust load
      • MOTOR: Three phase torque curve, air-filled, squirrel cage induction. Insulation Class: H
      • VOLTAGE: Dual Voltage 230/460; Requires overload protection to be included in control panel.
      • PROTECTION: Temperature sensor, requires relay in control panel.

Performance:

Model Hp Pole Volt.
Ph
Max.
amps
Impeller
Dia.(in)
100WQ3-4P 3 4 230/460/3 14/7 6.70"
100WQ5-4P 5 4 230/460/3 19/9.5 7.25"
100WQ7.5-4P 7.5 4 230/460/3 30/15 7.90"
100WQ10-4P 10 4 230/460/3 34/17 8.0"
100WQ15-4P 15 4 230/460/3 44/22 9.13"
100WQ20-4P 20 4 230/460/3 50/25 9.5"
100WQ25-4P 25 4 230/460/3 64/32 10"
100WQ7.5-6P 7.5 6 230/460/3 24/12 10"
100WQ10-6P 10 6 230/460/3 29/14.5 11"